ribbon.png

Filler 2K - 5.1- Grey
A polyvalent, two part acrylic primer from ST technology with considerable High Solid characteristics on application. It respects the most restrictive European regulations in terms of emissions (2004/42/EC). It is characterised by extremely flexible use (high fill capacity, filling capacity, insulation and wet-on-wet) and by optimum dilatation and sanding ease. Available in a chromatic scale from white to black.

Scratch Resistant Clear 2K
223W.AIR is the clear 2K, able to minimize the problem of the drying time and of the dilatation on WB base-coat too. 223W.AIR is therefore especially recommended for complete or partial repairs, permitting very fast touch-ups without using the oven. After about 40 minutes at a temperature of even 15 degrees, 223W.AIR can be handled and any impurities can be removed by polishing at the end of 2 hours.

Cycle Green Car (low VOC), standard cycle, rapid cycle, motorbike cycle

Hardener H.S.
Cycle Green Car (low VOC), standard cycle, motorbike cycle, bus cycle and truck cycle

Primer X Plastic
Cycle Green Car (low VOC), standard cycle, rapid cycle, motorbike cycle, bus cycle and truck cycle, industrial cycle

Multicryl Standard Thinner
Cycle Green Car (low VOC), standard cycle, motorbike cycle, bus cycle and truck cycle

Polyurethane Solvent
bus cycle and truck cycle, industrial cycle

Epoxy Filler
Multi-purpose two-component epoxy filler. It can be used as filler, sealer, corrosion preventer or adhesion primer.

Plastic Adhesion Promoter
Single-component primer for plastics. A-Tech™ Product Range.

Unifiller 4+1 2K MS
Bicomponent filler made up of acrylic resins with high filling and insulating power.

Etch-Primer
Bi-component primer for plastics. A-Tech™ Product Range.

2K Polyurethane Filler
Good adhesion; good thickness; ease of sanding. This product can be colored and when combined with Syncron® 2K finishes, it guarantees a cost-effective and high-performing painting cycle.

Fast Drying Antirust
Good anticorrosion power and adhesion. This product can be colored and when combined with Syncron® nitro-synthetic and high-dried finishes, it guarantees an extremely rapid and high-performing painting cycle.

Epoxy Antirust
Excellent adhesion both on bare iron and light metals; good anti-rust power; good ease of sanding; possible wet-on-wet cycle. When colored, it can be covered with Syncron® finishes, such as 2K and epoxy.

2K Polyurethane Finish
Adhesion, brightness, chemical-physical resistance are its main characteristics.

Acrylic 2K Finish
The better quality of acrylics in terms of chemical-physical resistance compared with polyurethane products, makes this 2K Finish be at the top of Syncron® product line.

Fast Drying H.R. Finish
This product combines the characteristics of high-dried Finishes with a good chemical-physical resistance.

Epoxy Finish
Excellent adhesion on iron and light metals; good brightness. Appropriate for surfaces needing a high chemical resistance.

Go to top